Neue GH701SS Manual de usuario

User manualHobGH701GB

The hob should not be installed in a bed sitting roomwith a volume of less than 20 m³. If it is installed in aroom of volume less than 5 m³ an air ven

5. Replace the rating plate (it is near the gas supplypipe) with the one for the new type of gas supply.You can find this plate in the package supplie

ABCDEA) Green and YellowB) 3 amp fuseC) BrownD) Cord clampE) BlueThe wires in the cord are coloured as follows:Green and yellow - EarthBlue - NeutralB

Possibilities for insertionKitchen unit with doorThe panel installed below the hob must be easy to re-move and let an easy access in case a technical

Burner Ø By-pass in 1/100 mm Burner Ø By-pass in 1/100 mmAuxiliary 28 Rapid 42Semi-rapid 32 Triple Crown 56Gas burners for NATURAL GAS G20 20 mbarBURN

that you have proof of purchase and the followinginformation available:Model No . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

397320101-A-232013

ContentsSafety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3Product description _ _ _ _

• Never try to extinguish a fire with water, but switch off the appliance and thencover flame e.g. with a lid or a fire blanket.• Do not store items o

• Make sure that there is air circulation around the ap-pliance.• The information about the gas supply is on the ratingplate.• This appliance is not c

• Contact your municipal authority for information onhow to discard the appliance correctly.• Disconnect the appliance from the mains supply.• Cut off

ABCDA) Burner capB) Burner crownC) Ignition candleD) ThermocoupleWarning! Do not keep the control knob pushed formore than 15 seconds.If the burner do

Care and cleaningWarning! Refer to the Safety chapters.Warning! Deactivate the appliance and let it cooldown before you clean it. Disconnect theapplia

TroubleshootingProblem Possible cause RemedyThere is no spark when lighting thegas• There is no electrical supply • Make sure that the unit is con-nec

If there is a fault, first try to find a solution to the problemyourself. If you cannot find a solution to the problemyourself, speak your dealer or t