
3. The outlet or omnipolar switch used for connection
is easily accessible with the appliance installed.
The appliance is supplied with a 3 core flexible power-
cable with a 3 amp plug. If it is necessary to change the
fuse, use a 3 amp ASTA-approved (BS 1362) fuse.
AB
C
D
E
A) Green and Yellow
B) 3 amp fuse
C) Brown
D) Cord clamp
E) Blue
The wires in the cord are coloured as follows:
Green and yellow - Earth
Blue - Neutral
Brown - Live
Replacement of the connection cable
1. Connect the green and yellow (earth) wire to the
terminal which is marked with the letter 'E', or the
earth symbol
, or coloured green and yellow.
2. Connect the blue (neutral) wire to the terminal
which is marked with the letter 'N' or coloured blue.
3. Connect the brown (live) wire to the terminal which
is marked with the letter 'L'. It must always be con-
nected to the network phase.
There must be no cut or stray strands of wire present.
The cord clamp must be correctly attached to the outer
sheath.
To replace the connection cable use only
H05V2V2-F T90 or equivalent type. Make sure
that the cable section is applicable to the voltage load
and the working temperature. The yellow/green earth
wire (B) must be approximately 2 cm longer than the live
and neutral wire (A).
AB
Warning! A cut off plug inserted into a 13 amp
socket is a serious safety (shock) hazard. Ensure
that the cut off plug is disposed of safely.
Important! The replacement of electric cable must be
carried out exclusively by the service force centre or by
personnel with similar competencies, in accordance with
the current regulations.
Building In
min. 55 mm
min. 650 mm
550 mm
min. 600 mm
30 mm
470 mm
min. 600 mm
A
B
A) supplied seal
B) supplied bracket
Caution! Install the appliance only on a worktop
with flat surface.
11
Comentarios a estos manuales