Neue GH601SS Manual de usuario descargar pdf (Pagina 10)

Location

The hob may be located in a kitchen, a kitchen/diner or

bed sitting room (with a volume greater than 20 m³), but

not in a bathroom or shower room.

The minimum distance combustible material can be

fitted above the hob in line with the edges of the hob is

400 mm. If it is fitted below 400 mm a space of 50 mm

must be allowed from the edges of the hob.

For appliances installed in the Republic of Ireland

please refer to NSAI- Domestic Gas Installation I.S 813

Current Edition Section 7- Permitted Locations of

Appliance.

Gas Connection

Warning! Any gas installation must be

carried out by a GAS SAFE REGISTER

installer.

Make sure that, once the hob is installed, it is easily

accessible for the engineer in the event of a breakdown.

The manufacturer will not accept liability, should the

above instructions or any of the other safety instructions

incorporated in this instruction booklet be ignored.

On the end of the shaft, which includes the G 1/2"

threaded elbow, adjustment is fixed so that the washer

is fitted between the components as shown in the

diagram. Screw the parts together without using

excessive force.

A B C

A) End of shaft with nut

B) Washer

C) Elbow

Connection to the gas supply should be with either rigid

or semi-rigid pipe, i.e. steel or copper.

The connection should be suitable for connecting to R

1/2 (1/2 BSP male thread).

When the final connection has been made, it is

essential that a thorough leak test is carried out on the

hob and installation.

Make sure that the main connection pipe does not exert

any strain on the hob.

If you use flexible metal pipes make sure that they

agree to ISO 10380 and ISO 10807 standards. Be

careful they do not come in touch with mobile parts or

they are not squeezed. Also be careful when the hob is

put together with an oven.

Caution! It is important to install the

elbow correctly, with the shoulder on the

end of the thread, fitted to the hob

connecting pipe.

Caution! Failure to ensure the correct

assembly will cause leakage of gas.

Caution! Make sure that the gas supply

pressure of the appliance obeys the

recommended values.

Rigid connection:

Carry out connection by using metal rigid pipes (copper

with mechanical end).

Injectors replacement

1. Remove the pan supports.

2. Remove the caps and crowns of the burner.

3. With a socket spanner 7 remove the injectors and

replace them with the ones which are necessary for

the type of gas you use (see table in "Technical

Information" chapter).

4. Assemble the parts, follow the same procedure

backwards.

5. Replace the rating plate (it is near the gas supply

pipe) with the one for the new type of gas supply.

You can find this plate in the package supplied with

the appliance.

If the supply gas pressure is changeable or different

from the necessary pressure, you must fit an applicable

pressure adjuster on the gas supply pipe.

Adjustment of minimum level

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the knob.

4. With a thin screwdriver, adjust the bypass screw

position (A).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios

Neue GH601SS Manual de usuario Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Neue GH601SS